Back

Aztech DSL700P

Install Driver in Windows 95B
Note:

• Ensure that you have installed the Aztech DSL700P Card properly into the Computer
• Ensure that you have inserted the Aztech DSL700P Installation CD into the CD ROM or downloaded the driver
• Ensure that you have the Windows 95B installation CD ROM

1. When you startup the system ,the Windows will detect the Aztech DSL700P Card
2. You should see the Hardware Wizard window appears as shown below
3. Click on Next > button to continue




4. Click on Other Locations... button




5. Click on Browser button




6. Select the CDROM drive and then "2_Win95" folder
7. Click on OK button




8. Click on OK button to continue




9. Click on Finish button




10. Please wait while the Windows is copying files
11. If windows prompts for Windows 95 CD-ROM, remove the Aztech CD-ROM from the CD-ROM drive and insert the Windows 95 CD-ROM. Click on OK button




12. Proceed for the Windows files installation
13. Click on OK button to restart the system




14. Please wait for a few minutes for the Windows to startup
15. You should see a window appears as shown below
16. Type in the IP address and the Gateway IP

(Please refer to service letter for the IP address)
17. Click on OK button the apply the changes




18. Click on OK button to restart the system




19. After the system restarts , you should see a small icon at the system taskbar




20. You are ready for surf the Internet and read your emails
21. You have successfully installed the Aztech DSL 700P driver onto the Windows 95B