Back

Aztech DSL700P

Install Driver and configure Network settings in Windows XP
Note:

• Ensure that you have installed the Aztech DSL700P Card properly into the Computer
• Ensure that you have inserted the Aztech DSL700P Installation CD into the CD ROM

1. When you startup the system ,the Windows will detect the Aztech DSL700P Card
2. You should see the Hardware Wizard window appears as shown below
3. Tick the option "Install from a list or specific location (Advanced)" and click on Next > button




4. Tick the option "Include this location in the search :" and click on Browse button




5. Browse to the CDROM drive and select "5_WinXP" folder
6. Click on OK button




7. Click on Next > button




8. Click on Continue Anyway button to continue




9. Please wait while the Windows is copying files




10. Click on Finish button to end the installation




11. Next is to configure the Network settings
12. From the windows desktop, double click on My Network Places icon




13. Double click on Local Area Connection icon




14. Select the option "Internet Protocol(TCP/IP)" and click on Properties button




15. Tick the option "Use the following IP address" and type in the IP as follows:

IP Address : Please refer to your service letter
Subnet mask : 255.255.255.0
Default Gateway : follow the IP address except the last number is 2 e.g. XXX.XXX.XXX.2
16. Tick the option "Use the following DNS Server Addresses" and type in the DNS servers as follows:

Preferred DNS Server : 165.21.83.88
Alternate DNS Server : 165.21.100.88
17. Click on OK button




18. Click on OK button to close the TCP/IP window
19. Click on OK button to close the Local Area Connection window
20. You are ready for surf the Internet and read your emails
21. You have successfully installed the Aztech DSL 700P driver onto the Windows XP