Back

Efficient SpeedStream 3060

Configure ATM / Network Settings in Windows 2000
Note:

• Ensure that you have successfully installed the Efficient 3060 Driver before you proceed the installation below

1. Connect the ADSL line to the Efficient 3060 Card
2. Please wait a while to see a wizard window appears as shown below
3. Unplug the ADSL line from the Efficient 3060 Card
4. Click on Next> button




5. Select "Manually enter connection information" and click on Next> button




6. Leave the default settings and click on Next> button




7. Select "PPP Over ATM VCMUX Encapsulation" and click on Verify button




8. Click on Save button




9. The driver will create 2 "SpeedStream DSL" icons at the Dial-Up Networking and Windows Desktop. These dialers are useless to the ATM Connection and we recommend you to delete them away as shown :
1. Go to windows desktop and select "SpeedStream DSL" icon
2. Right click on the mouse and select Delete option to remove it
3. Go to My Computer > Control Panel > Network and Dial-up Connections and select the "SpeedStream DSL" connection icon
4. Right click on the mouse and select Delete option




5. Click on Yes button to confirm




10. Ensure you are at Network and Dial-up Connections window
11. Next is to select "ATM Connection" icon
12. Right click of the mouse and select Properties option




13. Check the option "Show icon in taskbar when connected"
14. From the component window , check the options "ATM Call Manager" and "Internet Protocol"




15. Configure Internet Protocol
1. Select "Internet Protocol" and click on Properties button
2. Configure the settings as follows :

Check the option "Use the following IP address:"
• IP address : please refer to the Service Letter
• Subnet mask : 255.255.255.0
• Default gateway : follow the IP address except last number is 2

Check the option "Use the following DNS server addresses:"
• Preferred DNS server : 165.21.83.88
• Alternate DNS server : 165.21.100.88


3. Click on Advanced... button




4. Click on ATM ARP Client Tab




5. Check the option "PVC only"
6. Click on OK button




7. Click on OK button to end Internet Protocol settings


16. Configure ATM Call Manager
1. Select "ATM Call Manager" and click on Properties button
2. Click on Add... button




3. From the Application type , select "ATM ARP" option
4. Configure the settings as follows :
• Name : magix
• Virtual path ID : 0
• Virtual circuit ID : 101
• ATM adaptation layer : AAL 5


5. Click on Advanced... button




6. If you see some values on the settings , leave the settings as default and click on OK button




7. Click on OK button to end ATM Call Manager settings


17. Click on OK button to end ATM / Network Settings
18. Please wait a while and you will see this icon appears at the taskbar
19. Double click on it




20. The status show that you are connected to Magix Service




21. You have successfully configured ATM / Network settings onto Windows 2000.

Proceed to "Enable and Disable ATM Connection in Windows 2000".